Both are 6'-1" x 20-1/2" x 2-5/8". Plenty of foam but the rails are thin for easy penetration
Inspired by Bumblebee and CI Bonzer 3-D. Intended as a daily drivers with good top end.
The figured walnut one I'm going to sell. The grain figure really "pops" in the sun. I'm afraid it might end up on a wall.
I'm might ride the green railed one, which has my preferred grain pattern(in this case French Walnut). It's the one where the veneer curled up as soon as the resin hit it and the vac bag couldn't pull it flat. It created depressions on the bottom and ridges on the deck. I filled the depressions (you can see the pinkish purple hue of the UV resin where it pooled). I ground off the ridges on the deck and tried to paint to match the color. It was tricky because the wood changes color when the resin hits it in somewhat unpredictable ways. I figure it will be covered in wax anyways.
Inspired by Bumblebee and CI Bonzer 3-D. Intended as a daily drivers with good top end.
The figured walnut one I'm going to sell. The grain figure really "pops" in the sun. I'm afraid it might end up on a wall.
I'm might ride the green railed one, which has my preferred grain pattern(in this case French Walnut). It's the one where the veneer curled up as soon as the resin hit it and the vac bag couldn't pull it flat. It created depressions on the bottom and ridges on the deck. I filled the depressions (you can see the pinkish purple hue of the UV resin where it pooled). I ground off the ridges on the deck and tried to paint to match the color. It was tricky because the wood changes color when the resin hits it in somewhat unpredictable ways. I figure it will be covered in wax anyways.