REMINDER: THE ARENA PLATFORM, INC. has no obligation to monitor the Forums. However, THE ARENA PLATFORM, INC. reserves the right to review any materials submitted to or posted on the Forums, and remove, delete, redact or otherwise modify such materials, in its sole discretion and for any reason whatsoever, at any time and from time to time, without notice or further obligation to you. THE ARENA PLATFORM, INC. has no obligation to display or post any materials provided by you. THE ARENA PLATFORM, INC. reserves the right to disclose, at any time and from time to time, any information or materials that we deem necessary or appropriate to satisfy any applicable law, regulation, contract obligation, legal or dispute process or government request. Click on the following hyperlinks to further read the applicable Privacy Policy and Terms of Use.
Measuring fin placement from tail
- Thread starter dk1973
- Start date
Some fins are forward on the tabs and some back so you could get a skewed measurement from those.
With FCS, you can usually still see the shapers dot on the foam, which is where the shaper intended the trailing edge of the fin to be.
Futurds doesn't allow you that luxury
Thanks jkbTrailing edge of the fin, typically......if you're using the fin that the shaper intended for that board.
Some fins are forward on the tabs and some back so you could get a skewed measurement from those.
With FCS, you can usually still see the shapers dot on the foam, which is where the shaper intended the trailing edge of the fin to be.
Futurds doesn't allow you that luxury