REMINDER: THE ARENA PLATFORM, INC. has no obligation to monitor the Forums. However, THE ARENA PLATFORM, INC. reserves the right to review any materials submitted to or posted on the Forums, and remove, delete, redact or otherwise modify such materials, in its sole discretion and for any reason whatsoever, at any time and from time to time, without notice or further obligation to you. THE ARENA PLATFORM, INC. has no obligation to display or post any materials provided by you. THE ARENA PLATFORM, INC. reserves the right to disclose, at any time and from time to time, any information or materials that we deem necessary or appropriate to satisfy any applicable law, regulation, contract obligation, legal or dispute process or government request. Click on the following hyperlinks to further read the applicable Privacy Policy and Terms of Use.
*** Official Fin Thread ***
- Thread starter retodd
- Start date
as said above, they've had them for years. I have a set that is several years old
I run accelerators in my driver. Lost fins worked well too.
Personally, I would try the K2.1's in it first, then go from there.
The Accelerator mediums are pretty big for a medium fin. They are probably better described as being in-between a medium and a large......and the rear fin is the same size as the fronts. Might be too much fin for your weight.
You could try the small accelerators, but I found them too small for my taste.
Try pairing thruster set sides which feel too big with a smaller center. The 2.1 rear is the m3, which is why you can easily force them around. You can even throw in an m2 to make it even looser. I think a few people on here have done that to some success.
Someone once wrote on here that 90% of the magic of the k2.1’s is the smaller trailer. They were correct.
And to think years ago I just used whatever black plastic fins we had. G3000s.
Just found a single old ass vector future in an old board, not sure where the rest are, the blacksticks similar? (Inner foil )
Just found a single old ass vector future in an old board, not sure where the rest are, the blacksticks similar? (Inner foil )
If i were you , keep the k2.1 fins . I think the old foils and better than the new ones .
Second . Get a custom set From Griffin . Far superior to anything available
The old ones were scooped out all the way into the tip . Only fun in pure mush
I'm really digging this set-up on my buzzsaw, Archy fronts, and QD2 4.15 flat foil rears. I haven't actually given it a direct comparison to ST2 yet, but so far this has made this board magic!
K2.1s also have a pretty wide base and keep some width to the tip as well as being pretty upright so I think the special sauce isn't just the smaller rear.
Also at least some of the Merrick sets have a smaller rear but personally I don't jibe with them because of the narrower tips and the rake.
Also at least some of the Merrick sets have a smaller rear but personally I don't jibe with them because of the narrower tips and the rake.
They look like a less extreme take on the whale fin tubercles Slater was getting sanded into some of his fins a couple of years ago.