XTR Delams

surfadelphia

Nep status
Nov 15, 2010
677
650
93
Big ass delam under my back foot on an xtr mandala asq. Fucking love this board. Not sure it was actually glassed in house at XTR as there's no lams.
Drilled two little holes to vent. Syringe, epoxy, weight or just leave it as is?
 

racer1

Tom Curren status
Apr 16, 2014
12,922
14,982
113
Honolulu, Hawaii
I would just leave as is with the two drill holes. It won't absorb water and sealing again will just lead to another delam.
I had a XPS from FCD that delam'd under my front foot, I just poked one hole and left it. Board still rode for years no issue.
 

surfadelphia

Nep status
Nov 15, 2010
677
650
93
I would just leave as is with the two drill holes. It won't absorb water and sealing again will just lead to another delam.
I had a XPS from FCD that delam'd under my front foot, I just poked one hole and left it. Board still rode for years no issue.
how big was is? I want to just leave it as since it's relatively flat with the two little holes but it's around 16"x10" and might be too tough to ignore.

I wonder if people can order xtr through him. That would be rad
I dont think so, pretty sure I just got lucky on a used one off. I do wonder if it was glassed somewhere other than xtr
 
  • Like
Reactions: JDJ